
The Profiline comfort control system comes as standard equipment on the TOP 1403 C. This is optional on the TOP VT 12540 C. Load sensing or a power beyond system are required for this setup.
The rake is controlled either by using your ISOBUS tractor terminal or another control terminal such as the CCI 1200, EXPERT 75, or POWER CONTROL.

For maximum operating convenience, you can recall up three working widths and three raking heights independently of each other. Using this system you can adapt the rake to the site-specific conditions quickly and easily. The lifting height of the rotors can also be adjusted using the control panel and is measured using angle sensors.

When cornering, the overlap control moves the front rotor on the inside of the corner inwards automatically. Sufficient overlap with the rear rotor is then ensured at all times. When driving straight ahead again, the front rotor then moves out automatically. Using this system ensures that you make the most of the maximum possible working width.

Wedge-shaped swath mode makes it easier to rake wedge-shaped fields. When a front rotor is lifted or lowered, the respective rear rotors follows as soon as it reaches the same point. The left and right front rotors can be controlled independently of each other.
This mode can be easily activated in the Work menu.

Direct mode enables any rotor unit to be lifted without prior preselection of the rotor.
Being able to operate individual rotors quickly and conveniently is very helpful, especially when there are obstacles within the field.

Simply press a button to change from working mode to transport mode. Pressing the button again automatically retracts the working width of the machine as it folds in the rotors and locks them securely in place.

Rakes fitted with the Profiline comfort control system are Section Control capable as standard. With the corresponding equipment on the tractor, the individual rotor units can be automatically lifted and lowered at the headland, depending on the GPS position.

The weight alleviation of the front rotors is regulated automatically depending on the set working width and any undulations in the ground.
This ensures that the weight acting on the ground always remains constant. The sward is protected, the load on the rotor unit is reduced, and raking performance on steep ground is improved.