On 3-furrow models there is an additional reinforcement bolted to the beam. No holes or welds that would weaken the beam.
The forged press-formed section reaches under the turnover shaft to increase strength. A double acting reversing cylinder with check valve is standard; hoses are not under pressure during ploughing. Three top link positions, including a slotted hole for faster penetration and lower linkage control.
Cat. 2 mounting axle, Cat. 3 optional
The full-length mounting axle can be adjusted to four positions and has an anti-twist lock. The correct positioning on the tractor is therefore always retained to achieve optimum clearance at all times.
The turnover shaft is a solid shaft with a diameter of 80 mm. The tapered roller bearings are tensioned and adjusted using a castellated nut. The beam angle is adjusted using two turnbuckles.
Welded moulded leg mounting bracket
The bracket surrounds the plough beam tube with a large contact area to transfer forces to the beam.
Solid body mountings on both sides
Double-sided shear protection via shear bolts. Four furrow widths easily selected via hole matrix by moving a bolt.